Summer Breeze

Summer Breeze
©Barbara Butler
May 2014

Supplies:
Kit-Splash of Summer by Amy Marie.  This kit can be found at www.amymarieskits.com
Mask-CM_BB_ForumStyleMask1_MBW.  This I do believe you can fine at the Creative Misfits Blog.

We're going be making a banner and avatar so for the banner open up a new image about 600X250 72DPI. 

Select all and paste Pp5 into the selection.  Select none.  Apply the mask and merge the mask group.  Apply an inner bevel with the following settings:  2, 9, 0, 1, 6, 0, 315, 50,30, white.

Add a new layer, select all and paste Pp9 into the selection.  Move this down below the mask layer.  Go to effects and under image effects go to seamless tiling and apply it with the default settings.

C&P Element 7 on to the canvas.  Re size it twice, once by 45% then by 75%.  Place it in the bottom left corner.  Bring it to the top.

C&P Element 15 on to the canvas.  Re size it by 65% three times.  Flip it horizontally and place it in the top right corner.

C&P Element 28 on to the canvas.  Re size it by 45% once.  Place it on the bottom right.

C&P Element 29 on to the canvas.  Re size it by 45% twice.  Place beside the sunglasses.

C&P Element 35 on to the canvas.  Re size it by 45% once.  Place it behind the flower on the left side.

C&P Element 36 on to the canvas.  Re size it by 50% twice.  Place it towards the right.

C&P Element 51 on to the canvas.  Place it on the right side. 

C&P Element 69 on to the canvas.  Place this in front of the dolphin so it looks like the dolphin is jumping out of it.

Add a new layer, bring this to the top and C&P Element 64 into the selection.  Go back to the sunglasses and the seashell on the right side and bring them to the top.  With the sunglasses re size them one more time by 50%.  Do the same witht the elements on the left.  Re size the flower again by 65%.

For the avatar draw out a 200x200 rectangle.  Close all the layers except the yellow paper.  On the yellow paper copy and paste this as a new image.  Add a new layer, select all and paste Pp5 into the selection, select none and apply the same mask as before merge the mask group.  Add the same inner bevel.  Paste your tube of choice and re size it as needed.  Crop the image back down to 200 (if the tube is too big).  Add another new layer Select all and paste Element 64 into the selection.  Select none.

Paste Tube(s) of choice on to the canvas.  Re size it if needed.  Place to your liking.

Add name and save as a pspimage.  Add any effects you would like.  Crop and re size the tag.  Save as a png and you are done.

Thank you for taking a look at my tut.  I hope you have enjoyed it.